Azek Reserve Connector Manuel d'utilisateur télécharger pdf

In order to ensure beautiful installation of Trademark Reserve railing, we have four easy-to-use decorative

connector kits to ﬁt every angle: In-Line Top Rail Connectors, 22.5 Degree Top Rail Connectors, 45 De-

gree Top Rail Connectors and Post Connectors. Please see below for information on each application.

CUTTING THE TOP RAIL:

When cutting the top rail, allow for approximately

1/8” gap per side between corresponding top rails

to ensure adequate space for the In-Line, 22.5 De-

gree or 45 Degree Top Rail Connectors.

CONNECTOR INSTALLATION:

Slide the appropriate Top Rail Connector onto the

top rail. Slide the other top rail into the other end

of the connector with the assembled top rails over

the railing section. Press the top rails onto the

retainer, ensuring that they sit fully onto the re-

tainer. (TIP: If top rail is too snug to easily push on,

loosen the #14ss screws on the post brackets so

that the rail can be adjusted. Be sure to retighten

the screws when top rail is installed.)

POST CONNECTOR:

The Post Connector allows for a ﬂush clean at-

tachment to the post. Add a liberal amount of

caulking to the post side of the connector inside

the lip to adhere the connector to the post and

slide it onto the pre-cut Top Rail. Install the Top

Rail onto the sub rail Retainer, post side ﬁrst as

per instructions.

(NOTE: Remove any excess caulking with a damp

cloth.)

22.5 Degree Top Rail Connector

45 Degree Top Rail Connector

Post Connector

In-Line Top Rail Connector

ARIG_v1_0211

CONNECTOR KIT INSTALLATION GUIDELINES for

AZEK Reserve

Page 1

In order to ensure beautiful installation of Trademark Reserve railing, we have four easy-to-use decorative connector kits to ﬁt every angle: In-Line

Pas de commentaire

Azek Reserve Connector Manuel d'utilisateur